Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!

Yoyodyne integrated tailight

539 Views 1 Reply 2 Participants Last post by  So live
Cheers,
I’m looking to install a Yoyodyne integrated rear light/signal setup so that I can tidy up the back of my SS1000.
The kit comes with two 20w 5ohm resistors. These are the rectangular “sand”cast type with poor wire leads.

Can these resistors be swapped out for something smaller and easier to mount?
Has anyone here installed this taillight system?
Are the resistors necessary or are they just used to slow the blinking effect of the turn signal?
No schematic or instructions came with the package so I was curious as to how the resistors are installed.

Thanks.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top