Ducati.ms - The Ultimate Ducati Forum banner
1 - 1 of 12 Posts

· The days are getting longer!
8,231 Posts
Hi Stryder,

I got discouraged with all the staff you have to move.
Q1. Could I insert a rod, close to the dimensions of the axle and use the push-pull method, and lubricate simultaneously. Is it feasible?

Q2. If I follow your method. did you observe the possibility to put a grease nipple, either on the axle or the swing arm?

Thanks mate
The swing arm bearings are in the engine cases and the pivot shaft is inserted thru the swing arm and engine cases. The only way to lubricate this is to remove the pivot shaft.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.