Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!

Stiff Clutch... new slave or remove springs?

5001 Views 10 Replies 8 Participants Last post by  jcasella
So with dry clutches being typically heavier than their wet counterparts, what's the typical/recommended way to make the lever pull easier on the hand? I've read that upgrading the slave cylinder should reduce the stiffness by about 20-30%, but others just say to remove 2 springs from the clutch. If you're running a 1000desmo engine, does removing springs result in any clutch slippage? Anywho, just curious about people's opinions on this...
1 - 2 of 2 Posts

· Registered
Joined
·
90 Posts
Discussion Starter · #4 ·
hehe... aside from working out your left hand, would you say its a significant difference with the Evo slave? Also, if someone went the 'removing clutch springs' route, can you post a DIY guide?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top