Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 9 of 9 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
Does anyone have an alternate source for the small plastic washers that go behind the fasteners that secure the body panels? They're missing from half of my ST3.

Thanks in advance,
Brad-in-STL
 

·
Registered
2004 Monster S4R
Joined
·
506 Posts
Local hardware store as suggested.

An alternative is a fresh fairing bolt kit from eBay/Amazon in your choice of metal and color. They usually come with new washers.


2004 Ducati ST4s ABS “Senna”
2002 Yamaha FZ1
1998 Ducati ST2 apocalypse edition
 

·
Super Moderator
Joined
·
5,837 Posts
Like Mike and SoFun said, Lowe’s or any well stocked hardware store. Nothing special, just a nylon washer. Two bucks and you should be set for life.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
76 Posts
McMaster Carr has them and Stainless Steel button heads in all sizes needed.
 

·
Registered
2010 Ducati 848 Superbike
Joined
·
437 Posts
Man, living in this part of the world can suck sometimes...

No hardware stores that I've ever found here supply any hardware even remotely like the fasteners I need on my bike.

Any Aussies actually found any suppliers other than overprices eBay sites?
 

·
Registered
Joined
·
57 Posts
Purchased off these guys last year, quality good etc. Was hard to find nice thin washers, most of the hardware ones are 0.7 - 1.0 mm thick.
Can get in different sizes, purchased these for Dzus, but others available.
3GBP for 50 - roughly


https://www.ebay.co.uk/usr/speedyfasteners
 

Attachments

  • Like
Reactions: forsythem
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top