Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 2 of 2 Posts

·
Premium Member
Joined
·
79 Posts
Discussion Starter #1
I would love to hear anyone's input on if they think a project using the pistons mentioned above is feasible.

Could the case of an 1198 be bored that much? What about an 1198 cylinder?

Would be a sick motor, thats for sure! :D
 

·
Registered
Joined
·
13 Posts
I would love to hear anyone's input on if they think a project using the pistons mentioned above is feasible.

Could the case of an 1198 be bored that much? What about an 1198 cylinder?

Would be a sick motor, thats for sure! :D
I have had the same thoughts! But I think it is a big project due to the 6mm bigger pistons. The cylinderskirts will disapear or almost, you have to manufactor billet cylinders. Pinbolts are very close to cylinderskirt so they need a new wider place on case. Then wont the heads fit on pinbolts and so on,,,
But I dont think its impossible!

Edit! Take a look at this! http://www.ducati.ms/forums/56-superbikes/149755-1098-big-bore-project.html
 
1 - 2 of 2 Posts
Top