Ducati.ms - The Ultimate Ducati Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
... But get this. The fitting instructions say that the arrow collectors slip onto the stock header pipes that come out of the engine. My rear cylinder has a clamp with a joiner in where the arrow part can go onto, but my front cylinder runs straight out of the engine and into the catalytic converter. I looked at the parts manual from the Ducati website and it should have a short pipe out of the engine with a clamp to join the arrow pipes on. Why would mine be different?
 

·
Registered
Joined
·
762 Posts
Is your bike an 800 or 1000? They have different headers; the 800 has the short section from both cylinders. The 1000 only has the short section from the rear cylinder, and that is replaced by an Arrow part with the full system.

Is this the system you bought? It doesn't look like it is supposed to include clamps.

http://www.arrow.it//oggetti/2084_SC Ducati Monster S2 R 05.pdf

http://www.arrow.it//oggetti/3388_Ducati Monster S2R 800 - S4R.pdf

This is the system for the 1000. All of the OEM exhaust pieces are replaced on the 1000 system.

http://www.arrow.it//oggetti/2367_SC Ducati Monster S2R 1000.pdf

http://www.arrow.it//oggetti/3389_Ducati Monster S2R 1000.pdf
 

·
Registered
Joined
·
80 Posts
Discussion Starter #4
Is your bike an 800 or 1000? They have different headers; the 800 has the short section from both cylinders. The 1000 only has the short section from the rear cylinder, and that is replaced by an Arrow part with the full system.

Is this the system you bought? It doesn't look like it is supposed to include clamps.

http://www.arrow.it//oggetti/2084_SC Ducati Monster S2 R 05.pdf

http://www.arrow.it//oggetti/3388_Ducati Monster S2R 800 - S4R.pdf

This is the system for the 1000. All of the OEM exhaust pieces are replaced on the 1000 system.

http://www.arrow.it//oggetti/2367_SC Ducati Monster S2R 1000.pdf

http://www.arrow.it//oggetti/3389_Ducati Monster S2R 1000.pdf

Yeah I definitely got the right system. But Only my rear cylinder has the joiner piece for the arrow parts to go into. My front cylinder runs straight into the catalytic converter with nowhere to join the arrow and stock parts up to
 

·
Registered
Joined
·
80 Posts
Discussion Starter #5
My bike is the 800. Only the vertical cylinder has the short piece tho. The horizontal rapper goes straight to the cat
 

·
Registered
Joined
·
762 Posts
I think you're saying that your bike doesn't have the joint in the photo below. That's strange. You may have to go talk to your dealer about the different header.
 

Attachments

·
Registered
Joined
·
80 Posts
Discussion Starter #7
Yeah that's right. The joint where the arrow system is supposed to go onto isn't there. I can't speak to a dealer either coz I live about 809 kms away from one. And they aren't very helpful.
 
1 - 7 of 7 Posts
Top