Ducati.ms - The Ultimate Ducati Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I'm slowly reviving my bike which is a VeeTwo Alchemy with a Mille motor.
Now sourcing bits n pieces for the electrical system and I was wondering if a shingdengen 3 phase mosfet type regulator will work and how to wire it up.
All the bevel drives had single phase 2 wire alts (?) up till the Mille/S2 where they went to a 2 phase 3 wire alternator. I think Pantah's, Paso's and Cagiva's might have used the same type as stock got used up.

I have seen diagrams where people have connected the upper and lower wire together (see pic) and then connected that and the centre wire to what I assume is a single phase regulator.

Anyone fitted a modern style reg to a Mille and how did you wire it up?
 

Attachments

·
Registered
Joined
·
93 Posts
My bike's older and only has 2 yellows. I got my Shendingen regulator from Jack Fleming at Roadstercycle: https://www.roadstercycle.com/

I had a few internet discussions with him; he's very knowledgeable.

I have a friend that just went through the same 2 yellow, 1 red question on his '83. I'll contact him, find out what he did and report back.
 

·
Premium Member
Joined
·
518 Posts
1 - 5 of 5 Posts
Top