Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 · (Edited)
I am looking for some advice for when I assemble my 900ss engine as I have taken the pick ups off without marking where the nuts sat to secure it.
Suggestions?

Or is it really that big of a deal?
 

·
Registered
Joined
·
3,800 Posts
well, if you want it to run right, yes, it is that big of a deal. i had a co worker set an engine at "tdc" using the dot on the timing shaft belt pulley, then express surprise at 1/ how badly it ran and 2/ how much better it ran when he did it right.

993658
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #3 ·
I knew it was an issue but didnt know how big of an ordeal it would be to get It running correctly again. Thanks for the info 👍
 
1 - 3 of 3 Posts
Top