Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
229 Posts
Discussion Starter · #1 ·
Okay, once I sorted out which screws released the "cover" over the wiring for the turn signals, getting them attached and wired up was easy. Problem is, now I can't get the cover back on! It goes in place sort of, but doesn't go down anywhere close to where it came apart. The edges are more than a quarter inch apart at the signals, and more than that at the lower screw behind the tag. I'll keep fiddling, but if someone has words of guidance, I'd appreciate it. Sweating me balz off out there.
 

·
Registered
Joined
·
229 Posts
Discussion Starter · #2 ·
Crisis averted. The mere suggestion that the collective wisdom of this forum was about to be brought to bear put the fear of the Almighty into the uncooperative bit of Italian plastic, which practically leapt into place.

Carry on.
 
1 - 2 of 2 Posts
Top