Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
I am about to do the valves on my mh900 with all the reading on the net including all he videos.
can't find a definite range that is ok before needing adjustment and actual value that is needed if out of range
Intake
Opener range. opener seting
Closer. Range. Closer seting
Exhaust
Opener range. Opener seting
Closer. Range. Closer seting
Thanks
erick
 

·
Registered
Joined
·
1,620 Posts
Hi Erick,
Here is what I set the clearances to on the 8 mm 2V motors:

Closers: 0 to .002 in.
Inlet Openers- .004 in.
Exhaust Openers- .006 in.

I try and get them as close to these clearances as possible. I find the bike runs smoother when the clearances are optimum.
Mike
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top