-
Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
Installing motowheels slipper clutch...HELP!
We're currently installing our MotoWheels slipper clutches:
Linky
We took one of them appart from how it came from Motowheels, started installing and left the other one intact so we could tell the order of everything when putting the first one back together.
Well...we're confused.
You put the basket in, and put all those bolts in, then you put the hub in, then put the plates in, then there's this spider spring. It has 6 legs. It goes in, then there's this washer that fits down in the hole that goes around the push rod. Then there's the nut that holds all that together...
Then what?
The way it all came from Motowheels, the next thing is this steel curved washer then this thicker standoff....but how are you supposed to keep the washer in place? It drops down and hangs off of the pushrod and there's no way to hold it in place, same with the thicker standoff washer.
I put a bit of grease on the steel washer and placed it against the nut to hold it in place, then put everything together, put the 6 springs in and tightened everything down.
When I pull the clutch, it doesn't pull even, the pressure plate doesn't pull in evenly and I'm sure that's not right!
Anyone have any ideas?
Anyone?
Linky
We took one of them appart from how it came from Motowheels, started installing and left the other one intact so we could tell the order of everything when putting the first one back together.
Well...we're confused.
You put the basket in, and put all those bolts in, then you put the hub in, then put the plates in, then there's this spider spring. It has 6 legs. It goes in, then there's this washer that fits down in the hole that goes around the push rod. Then there's the nut that holds all that together...
Then what?
The way it all came from Motowheels, the next thing is this steel curved washer then this thicker standoff....but how are you supposed to keep the washer in place? It drops down and hangs off of the pushrod and there's no way to hold it in place, same with the thicker standoff washer.
I put a bit of grease on the steel washer and placed it against the nut to hold it in place, then put everything together, put the 6 springs in and tightened everything down.
When I pull the clutch, it doesn't pull even, the pressure plate doesn't pull in evenly and I'm sure that's not right!
Anyone have any ideas?
Anyone?
