Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
177 Posts
Discussion Starter · #1 ·
Hey peeps,

I tried to remove my OEM clutch reservoir today from my '06 999, as it's been leaking lately and I need to replace it. However I just can't for the life of me remove it from the master cylinder unit. I removed all brake fluid from the reservoir, gave it a good wipe, and removed the small screw that is inside the reservoir.
However, even after that the plastic reservoir was as rock solid as before! :think:
I tried pulling it or just moving it around but it won't budge. What gives? Am I missing something here?

Any help will be highly appreciated guys!

Cheers,
 

·
Registered
Joined
·
177 Posts
Discussion Starter · #5 ·
All great advice guys! Many thanks!
Just to be on the safe side I found a brand new reservoir and I will also replace the bleed fitting with a new one. I hope this sorts it all out. (I don't really fancy brake fluid over my fairings). :rolleyes:

Will let you know how it goes.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top