Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2021 HERE!
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)
Hi everyone,

I did a search on this forum and other forums and could not find out how to fit my new DP clutch into my 2001 996. The DP Clutch part DPSK 232F will fit other models as well. The parts in the kit:

1 small concaved/dished steel plate
2 thicker steel plates
7 thinner steel plates
8 fiction plates
6 springs

I ended up emailing DP and below is the response I got from Frank from DP.

Our clutch kit as you say has 8 plates. The way to fit this kit is as follows:

First fit is the bevelled shaped small steel plate with the concave or dish facing you. Next is one of the two thick steel plates in this kit. Then Fiber-Steel etc until last plate is the second of the thicker steel plates.

Thought I could share this to everyone because my kit didn't come with instructions and my original clutch had 2 concave steel plates and 7 fiction plates. If this was one another thread, I'm sorry for being redundant.

Thanks,

Rob
 
1 - 2 of 2 Posts
Top