Ducati.ms - The Ultimate Ducati Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
638 Posts
Discussion Starter #1
I can't find anything in the manual about resting it...

When I am trying to use the LAP by flashing the PASS, it
keeps saying "FULL"...

Thx!

------

Lap time display
To activate this function, go into the menu and set the “LAP”
function to “On” by keeping button (1,fig.8) in position B
“▼“ for 3seconds.
START and STOP the timer by pressing the high beam
FLASH button (12,fig.5) on the left-hand switch.
When the LAP function is active, each time you press the
FLASH button, the display will show the lap time for
10seconds, before reverting to normal mode.
You can save a maximum of 30 laps in the memory.
If the memory is full, each time you press the FLASH button,
the display will not save any more lap times and will display
the flashing message “FULL” for 3seconds until the
memory is reset.
 

·
Registered
Joined
·
17 Posts
hold it down (B) for 3 seconds in the "LAP MEM" browsing mode, it will reset all times.
 
1 - 2 of 2 Posts
Top