[jiigan]

Hey guys, I bought an integrated led tail light. The light plugs in and works so does the brake light. The issue is with the turn signals. They only have one wire, the stock wiring has 2. Any suggestions on wiring?

 

[davy.j]

Do they share a common earth wire with the stop/tail light ?

 

[jiigan]

Do they share a common earth wire with the stop/tail light ?

I dont believe so, if I wire the yellow to positive of the oem harness the turn signal blinks once and thats it.

 

[davy.j]

Ask the supplier then.

 

[jiigan]

Ask the supplier then.

Supplier is chinese lol

 

[jiigan]

Essentially I would like to know if its possible to wire these if not I will return them.

 

[Ricko]

The bike supply +12v to the flashers when key is on
Ecu provide ground altrrnatively (on-off-on...)

So I guess you will need to use the 2 wires from the bike to power a relay with maybe a resistor in parallel so the flash speed is correct. Then use the output of the relay to provide +12v at your wire from the tail light. Of course you need this on both sides.

 

[jiigan]

The bike supply +12v to the flashers when key is on
Ecu provide ground altrrnatively (on-off-on...)

So I guess you will need to use the 2 wires from the bike to power a relay with maybe a resistor in parallel so the flash speed is correct. Then use the output of the relay to provide +12v at your wire from the tail light. Of course you need this on both sides.

Better return them then and just buy competitionwerks. Thank you.