Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2021 HERE!
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Speedy Moto frame slider kit is on the way for my SC 1000s. Never done this before and would like to ask any advice from you guys that have installed these. Seems it's a pretty straight forward install just curious if there is anything I need to do to make the installation go smoothly. It looks like the bolt travels through the engine casing - should I support the motor from below with a block of wood or something to keep it from moving downward once the original bolt is removed or will it all stay in place.

I searched the forums to check what torque the engine mount bolts should be and found 60nm to be the spec. What is that in Foot Pounds ? 44 ?

Thanks again and I do appreciate any tips you can offer


hedly
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Use a jack under the engine with a piece of wood so you can line up the holes for the bolt. Notice the difference in quality between the Speedymoto and Duc bolts. I got another high quality one for the other mount. Don't know if it does anything but I feel better. :)
Thanks, not sure what you mean by the quality of of the Speedy Moto supplied bolts. Is this the through the engine bolt or others...again - sorry but never done this before so I'm just looking for what to expect. When you did your install, did you tighten everything up using a torque wrench or just snugged it all up tight

Hedly
 
1 - 2 of 2 Posts
Top