Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2021 HERE!
1 - 2 of 2 Posts

·
Registered
Joined
·
1,845 Posts
Heat and penetrating oil should work if they're not corroded in the threads too badly.
Take the parts off the bike and put them in the oven for a few hours at 250 degrees. Then put them in the freezer for a couple. What this does is to take advantage of the dissimilar expansion rates of the materials. With this expand contract regime perhaps the penetrating oil will soak in and you can work the screws till they come out. Do it a few times and I hope it works. If you heat it over say,, 350, you'll have to replace any internal O rings if so equipped.
 
1 - 2 of 2 Posts
Top