Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
Well, I snapped one of the studs on the horizontal cylinder while removing the exhaust header. Managed to get the stud out, but now I need to replace it. I've searched a lot, and found studs for many Ducatis, but nothing that specifically said multistrada. Does anyone know what size stud I need for a replacement? And where best to get them, if possible.
 

·
Registered
Joined
·
391 Posts
I snapped one a few years ago installing my exhaust. Went like butter because install torque is very low, like 10nm, so check before you re-install.
 
1 - 4 of 4 Posts
Top