Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
4,748 Posts
the problem is getting inside the steering stops. you can uses a big cold chisel to push the bottom race up by hitting into the gap between bottom race and seal. just don't hit into the stem once it starts to move. or put a couple of dobs of weld on the race to use as knocking points. just not too much - if it goes cold it'll shrink and be stuck stuck.

i use the bikeservice tool - it's very easy.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top