Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
2,442 Posts
pay close attention to the clutch pushrod.make shure its straight and it should not spin much when assembled.if it does the bearing is likely needing replaced.the big seal behind the basket also can go bad.its a pita to change ,so determine if the oils coming from behind the basket.(big seal)or from the drum(closer to the center )(the o-rings)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top