Ducati.ms - The Ultimate Ducati Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
300 Posts
Discussion Starter #1
Does the 999 and the 1098 have the same width center to center of the forklegs?
Do they use diffrent kind of bearings?

Im looking for offset triples for my sc1000 and found attack ones for a good price but they are for the 1098 and my complete front end is 999.
 

·
Registered
Joined
·
797 Posts
I bolted a stock 1089 top tripleclamp onto my 2006 999S, fit perfect....
 

·
Registered
Joined
·
797 Posts
I bolted a stock 1098 top tripleclamp onto my 2006 999S, fit perfect....
 

·
Registered
Joined
·
16,908 Posts
I have not tried the 999 or 1098 triples on the SC. I don't know if I would like the 36mm offset on that bike.

We installed some 30mm offset SPEEDYMOTO Triple Clamp Set: Sport Classic on our Sport Classic project bike. We were planning to install some SBK Ohlins on the bike and mill the top to a 53mm and then shim the bottom--but we were lucky to find a Ohlins off of a S4RS so it just bolted up.

If you wanted these for the SC and 999 forks---I would mill them out to 53mm on the top.

The gauges mount right up to the top triple. The gauge angle was much better than the original.




 

·
Registered
Joined
·
300 Posts
Discussion Starter #5
I bolted a stock 1098 top tripleclamp onto my 2006 999S, fit perfect....
But that was only the top one not the bottom with stem?

Im gonna go back to 25mm i had 36mm on track this summer it worked great but is hoping for improvment with stock offset.

I ride an modified sport classic on track so its a little bit of an hybrid.
 
1 - 5 of 5 Posts
Top