Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
101 Posts
Discussion Starter · #1 ·
I snapped off :surprise: most of the little plastic tab that is used by the over-center clamp to hold the air runner to the air box. A little stub remains. Any recommendations on what to use to build up enough material so the clamp can capture it? I've planning on going the JB weld route, but if someone has a better idea I'd love to hear it!
 

·
Premium Member
Joined
·
5,151 Posts
Don’t even worry about it. The runner go over the intake duct on the front fairing and will stay in place. In other words it pushes the runner into the a airbox
 
1 - 2 of 2 Posts
Top