[mjmcnall]

Hey Guys,

I recently swapped out the gas tank and fuel pump on my 99 748.
When I took the tank off, I noticed that:
1) there is only one tube leading to the canister
and
2) it wasn't hooked up

I was going to hook it back up, but really I need to replace the two smaller sections of tube and the three way union that connects them to the tube leading to the canister. I've checked around local automotive stores for a part that would work but haven't had much luck.

Does anyone know where I could order one of these bad boys from?

I've attached a pic for reference.

thanks
Mike

 

[super dooper]

If I get what you are talking about, You do not need to connect that hose to the black canister. If you simply run the 1 hose down to the bottom of the fairing, you should be good to. I have that same set up on my bike.

 

[mjmcnall]

yeah, I did some reading and discovered that I don't need to connect the canister back up, but it'd still be nice to have the correct connections to run the tube down through the frame.

Also, since I'm asking potentially stupid questions, there is a much thinner tube that was also not connected that runs from under the fuel pump down to the front of the engine. The only thing it would seem to fit is the pressure regulator but I wasn't sure there was supposed to be a hose on that.