Ducati.ms - The Ultimate Ducati Forum banner

29mm Oberon Clutch slave (y/n?)

3K views 12 replies 7 participants last post by  Rex Coil 7 
I've already seen (and saved to my hard drive) that chart you've posted. I found it yesterday in some other posting while I was attempting to do some research on this very topic of the Oberon 29mm slave.

I'm aware that I may have to change the master to accommodate the 29mm Oberon, but I had no idea which Ducati master was correct. Thanks to your posting above, I now know which one! So 1098 it is! (~~begins search on eBay~~)

Re; hydaulic lines ... I think Spiegler will also make lines to order. At least they used to. In any case, the information you've provided is deeply helpful ... to me and anyone else looking into this same subject. You're a legend, man!

T'anks.
I don't know how it compares (piston size) to the coffin master, but I have an Oberon slave on my SL, which has the original master (with the small round remote reservoir) - and it works just fine.
 
  • Like
Reactions: BelgianDuc900SS
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top