Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
1,910 Posts
Try these guys, they may have a rebuild kit or help you out. www.mgcycle.com They specialize in Moto Guzzi service, but many items are shared across manufacturer lines.

Another alternative, it'll require some leg work, is to measure all the components where the o-rings contact. Bore inside diameter, cylinder outside diameter (at the ID of the o-ring) and the width of the outside diameter groove. And the thickness of the o-rings.

Then go to a place that sells o-rings, like Greene Rubber. More than likely, they'll recommend a Viton material. An alternaltive would be Buna-N.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top