Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 1 of 1 Posts

29 Posts
Discussion Starter · #1 ·
I've got the brass QR fuel line fittings here to replace the plastic ones on my 1199, any suggestions on how to remove the half that sits in the fuel line? I thought about hitting it with a heat gun to see if it softened up enough to slide it out, also considering wrapping tape around the line so I can squeeze it with pliers until the plastic barbed end pops, then fishing out the broken plastic. Or just get a new fuel line? I suppose any high pressure fuel line from the parts store with correct ID will work fine?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.