Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1 (Edited)
Hi Everyone,

Would someone be willing to show me the bolt and washer that is holding the air manifold / fairing to the oil filter? I checked the bolts / washers with a reputable shop, but they must not be right. With the bolts all the way screwed in, there's sufficient play that I can move the fairing back and forth :|
 

Attachments

·
Registered
Joined
·
291 Posts
Items 13 & 20 on the diagram are correct. The washer you have in the photo is incorrect. The washer should go onto the large shoulder under the head of the bolt. When you have the correct washer, it sits between the bolt head & the fairing section & acts as a soft seat for the mounting.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #4
Ah, ok, thanks! Sorry, just saw this. Perhaps my picture doesn't do it justice. The washer does fit over the thicker, non-threaded part of the bolt. But if I tighten it down, there's still play on the fairing.
 
1 - 4 of 4 Posts
Top