Joined
·
123 Posts
I'm installing an AiM MXL2 dash on my bike [*] and want to use the front/rear wheel speed sensors as inputs. Each sensor has the expected 3 wires, but rather then the obvious black = ground, red = +V and other == signal, they have Blue/Orange, White/Grey and Green. Based on the Leonelli website, I think it takes +12V in, so I assume it outputs +12 as well, but would love to hear more if anyone knows.
Normally, I'd use my multi-meter to figure out what wire is which, but I don't have a wiring harness to play with, but I do have the Leonelli wheel speed sensors Ducati uses on these bikes.
* The bike is actually a 1098S frame/suspension/etc, but the motor & wiring harness is from a SV650- hence the lack of a useful wiring harness to figure this out myself.
Thanks!
Normally, I'd use my multi-meter to figure out what wire is which, but I don't have a wiring harness to play with, but I do have the Leonelli wheel speed sensors Ducati uses on these bikes.
* The bike is actually a 1098S frame/suspension/etc, but the motor & wiring harness is from a SV650- hence the lack of a useful wiring harness to figure this out myself.
Thanks!
