Ducati.ms - The Ultimate Ducati Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Can anyone help me out with the O2 sensors connections on my 1198.
I removed my Termi slip-ons and reinstalled the stock exhaust but don't remember which connections to the O2 sensors go where. One connection is on the right and one is on the left. Does the front cylinder go to the left and the rear to the right?

Any help would be appreciated.

Thanks.


.
 

·
Premium Member
Joined
·
431 Posts
If it's the same as the 1098, than the lower pipe O2 sensor plugs in on the right side of the bike. And as far as the rear pipe the, I never knew there was an O2 sensor for it. Just pull up a parts diagram for 1198. Or you can easily download a service manual for an 1198 anywhere on the Internet for free.
 

·
Registered
Joined
·
39 Posts
Discussion Starter #3
Thanks for the feedback. If I'm not mistaken the 1098 only has 1 sensor? Mine has 2. One under the bike and one on the rear pipe near the shock. I have not been able to find a manual that shows what I am looking for yet.

.
 

·
Premium Member
Joined
·
431 Posts
Well i know my service manual fo my 1098S gives me a wiring route diagram and shows you exactly where the wire should be routed and plugged in, so a service manual for you bike should show that under the electrical section
 

·
Registered
Joined
·
39 Posts
Discussion Starter #5
Yeah, I was able to get a hold of a 1098 service manual but not a 1198 yet. The 1098 only shows 1 sensor so it doesn't help me any? I'm pretty sure I got it right but I just want to make sure.

Any one have a 1198 manual you could hook me up wit or at least look at?


.
 
1 - 6 of 6 Posts
Top