Ducati.ms - The Ultimate Ducati Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!

'04 SS 1000DS lower fairing & exhaust heat

1315 Views 7 Replies 7 Participants Last post by  ducvet
I've been busy with work stuff and haven't had a chance to ride in over a month. Today I opened up the garage door and pulled out all the bikes and started them just so they could get a little "exercise," basically I started them up to and let them idle in the cold temps. I let the bikes idle for close to ten minutes then went out to shut 'em down and that's when I looked down and noticed just how close the exhaust pipes are to the lower rear portions of the fairing. There's a small opening on both sides and on my bike I happened to notice that the lower left side opening seems a bit too close to the pipe.

Upon closer inspection is seemed okay and wasn't hot to the touch but when compared to the right side it just look right. I've searched the interwebs for pics of this area and all such pics do not resemble my bike, i.e., the fairing is too close to the pipe and seems a tad warped. I need to take a pic and post it. In the meantime does anyone here have feedback regarding high heat situations where the fairing warped??:confused:
1 - 1 of 1 Posts

· Registered
Joined
·
55 Posts
I put a used 1000ds fairing on my 900 and noticed it was melted in that same area. So I did put some extra spacers behind that bottom left bolt in order to force the fairing to open up a little bit more and be further away from the exhaust. Just check how much room you have before the side stand would rub on the fairing when retracted.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top