Ducati.ms - The Ultimate Ducati Forum banner

Search results

1-20 of 115 Results
Advanced Search
  1. 95 900ss motor

    Parts and Accessories
    95 900ss motor oil cooler, starter, aluminum kick stand was serviced by spectrum ducati at 12k (5 years ago) motor has 13k located in chino hills ca. $800.00
  2. Fuel hose replacement?

    Supersport
    Joe-b do you know what size the hole is in the brass jet
  3. Dyna coils???

    Supersport
    Vickon I bought my from California cycleworks they cost $199. It's a COMPLETE kit every thing you need comes with it. The kit includes plug wires (8mm), coils, all hardware for mounting and connecting. The things I notice after the installation was easier starting, smoother run, and better...
  4. Dyna coils???

    Supersport
    I went with the 5 ohm coils on my 91 900ss as suggested by cal. cycleworks and this dynatek post from there website. Q. Why does Dynatek recommend 5 ohm coils for street use and 3 ohm coils for racing? A. The resistance of the coil determines how much current flows through the ignition...
  5. Fuel leak / where's this screw go?

    Supersport
    TomT don't know if you had to lift the tank to trace your tail light problem. The reason I mention the pinch fuel return hose. You said when you open the fuel supply again the pump was quieter than when it was leaking out the float tube. The extra pressure put on the pump because of the...
  6. Fuel leak / where's this screw go?

    Supersport
    Could you have possible pinch the fuel return line.
  7. JB and Crew to Ducati

    Road Racing
    I think rossi will be good for the on going development of ducati bike early in the season I remember the announcer saying it took a special rider to get the most out of the ducati rossi won on the honda at that time it was the superior bike then went to yamaha which at the time was clearly not...
  8. damn mikunies /I want 1000ds engine?

    Supersport
    here's my 2 cents I did the 41fcr's tandems because syncing the carbs is virtually a one time deal the splits you do have to sync more often then a set of dyna coils to make starting easy ,throttle response better and engine run smoother
  9. gas tank dent removal?

    Supersport
    in the so.cal. area we have companies like painless dent removal that use special rods to massage the dent out with out damaging the paint ($60-$80) but it's up to the person doing the job and where the dent is and how severe
  10. Cam Pulleys

    Supersport
    I just order some Tuesday from Ben fox ( http://www.foxperformanceengines.com/) he has them in stock $299 for the set he's located in Colorado USA they are not listed on his website you need to call him the # 719-570-9595 mine should be here today they are the same as stm he had them made...
  11. Supersport Pictures - Let's See 'Em

    Supersport
    thanks for the explanation I thought the tubes were hooked the a sealed air box
  12. Supersport Pictures - Let's See 'Em

    Supersport
    MWR are the tubes a ram air system under the front of the fairing
  13. 91 900ss windscreen

    Supersport
    I been throwing around replacing the windscreen with a tinted one to help see the dash light during the day I was thinking a zero gravity double bubble but I have not found no pics any one have any pics of there windscreens
  14. low compresson reading

    Supersport
    the tests were done with the engine cold ignition switch off and modules unplugged (no concern for ecu it's a carby model) with both plugs removed and throttle wide open the deck height with base gasket remove was .042 hor.cyl. .045 vert cyl. I used wax to check this reading the bike runs good I...
  15. low compresson reading

    Supersport
    I was do a 1k service on a new motor with 11:1 je pistons all valves check good .004 on openers .002 on closers I did a compression test it only blew 132 psi hor.cyl. and 128 psi vert. cyl. which seem very low so then I did a leak down test and it only has 1% hor.cyl. 1.5% vert.cyl. at a 100 psi...
  16. Duc runs loud and weak at startup

    Supersport
    sounds like the pilot circuit of the carb is dirty
  17. fcr throttle

    Supersport
    I just installed a set of fcr's they came with a motion pro throttle and cables . So my question does any one make a quicker turn throttle tube to fit the motion pro throttle housing
  18. FCR Installation Question

    Supersport
    I just got done installing mine from ca. cycleworks side by side not splits you need to cut the air cleaner housing right above the cable bracket (just the webbing or vertical section) for clearance for the cables the cables from the throttle tube go over the front fairing brace around to the...
  19. 900ss cams

    Supersport
    does anyone know how to tell a 900 cam from a 750 cam with out measuring the lift any markings or visible appearance
  20. replacing cam belts

    Supersport
    Anatak. I have a 91 900ss and yes it is a pain in the butt to get the belts off. The easiest way I found to remove them was cut them off because you are replacing them anyway they go on easier than coming off. The belts still need some persuasion to get back on just be careful not to nick...
1-20 of 115 Results
Top