Ducati.ms - The Ultimate Ducati Forum - Reply to Topic
Thread: ST4S - which temp sensor controls the fan? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Ducati.ms - The Ultimate Ducati Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
Jul 27th, 2019 10:42 am
JasonWD On my ST2 I bought a 4x4 lightbar fitting kit on Amazon which came with a waterproof switch, relay, fuse and a complete harness.
Pretty easy to install...

... this did however point to a problem with my rear temperature sensor which is my next job.
Jul 17th, 2019 8:23 am
diddikai Thanks! That makes sense! Switch Ahoy...
Jul 17th, 2019 4:07 am
SS904 Doesn't work that way with the ST4s (or any of the ST series I believe). Fan is turned on by the ECU. If you managed to change the temp sensor to one that somehow reads lower, not even sure you can in this case, you will effect what the ECU sees as engine temp which will also effect the fuel map. Not the way to go.

There are two sensors on the ST. One is for the digital temp readout on the dash. The other is for the ECU. No dedicated fan sensor like you'd find in the older Superbikes. Those actually have three different sensors on the same journal. ECU, Fan and a small thermistor for the temp gauge.

If you want control of the fan, you would need to add a manual switch that will apply a ground to the coil of the fan relay. The ECU controls relays and such by turning on a ground path for the voltage that is already sitting there. Splice in a manual ground and the fan relay will energize. Probably easier and less expensive than changing a temp sensor.

I have not made the modification, but there are many who have. I remember a few threads on the subject offering which relay and wire to splice in the ground.
Jul 16th, 2019 5:46 pm
ST4S - which temp sensor controls the fan?

Hi Folks,

I'm fitting a bosch lower-temp-trigger sensor to lower the fan actuation temp, but am not clear on which sensor to replace as there are two and one is for the instrument cluster. Is the fan control sensor on the left side and denoted as #3 on the attached graphic? Advice appreciated!

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome