Missing Part, Maybe?

[alanime]

I bought my Hyper S used about two months ago. While I was installing the DP Sump Guard, I noticed something missing on my bike. I couldn't find out what it was from the parts manual. Can somebody help me out and tell me what is missing on my bike and what the parts number is so I can replace it? Thank you

[MarksFriggin]

I think that's where the muffler bearing goes.

[Da_Bull]

Originally Posted by MarksFriggin

I think that's where the muffler bearing goes.

Stop lying. That's where you're supposed to bolt the DP tool kit.

[Monstaman]

Originally Posted by MarksFriggin

I think that's where the muffler bearing goes.

Only on the low mount models tho, the high mount bearings are located next to thecontinuum transducere.

alanime, nothing goes on there mate so if you wonna use it for something you are good to go ... as long as it doesn't matter if it gets greasy.

[Crank1000]

I think that's where your swingarm goes! Are you missing the rear half of your bike by any chance??!

[archimedio]

Hah, hah, you guys are so funny...

Seriously, OP that's where your Fetzer valve should be. It screws in and a wire from it clips to the bung on the pipe right next to it. It's a $20 part and your dealer should have it in stock. Give em a call.

[johnchypermotard]

don't pay any never-mind to those jackasses ... listen to THIS jackass when i tell you nothing goes there ... it's not use on the hypertard.

[CodeRed]

Rumor is that is used when the bike was assembled on the line.

[alanime]

Thank you everybody. I was just worried that something was missing.

[richmeyer]

Nice garage!