Rizoma mirror mounting adapter question

[Barrel]

I've decided on my first mod (not counting the removal of the charcoal canister)...removal of the hand-guards and some mirrors in their place.

After much debate I'm going with rizoma circuit 743's (http://www.pjsparts.com/catalog/popup_image.php?pID=639).

I have a question though...using the mounting adapters (http://www.pjsparts.com/catalog/popup_image.php?pID=44) is there a way to adjust the "angle" of the mirror arms? In some photo's I've seen people with their arms at a low angle (with the mirrors close to their grips) and in other photo's people have had extremely high angles with their mirrors perched high.

I'm also going to go with rizoma bar ends to finish it off. By the looks of it I'm going to have to cut the bar at both ends?

Let the modding begin.

[Barrel]

oh yeah...added a 2009 1100S to keep the 748R company.

[Barrel]

anyone with rizoma experience? Thanks.

[Mati-O]

You mean these just Dremel the ends off. EXCEPT the throttle! leave a little piece of the tongs sticking out or youll bind the throttle with the end caps!!!!!!!!.take your time trimming down until you get the right depth. I got the Logic mirrors instead and both are hella adjustable its all up to you, You wanna buy'em 160.00 shipped no mounts though. before you make the cuts! not all grips are the same length so decide on a permanent set, the stockers are shorter than the PROGRIPS and all others out there FYI! If you decide to change to the rizoma twist throttle or any others the length is also different.