Zard Top Guns Dyno Run

[AXE]

I finally got everything (Zard Top Gun slip ons, DP ECU, DNA filter, modified air box lid) installed and got my Hyper over to the dyno at Euro Motorsports in Scottsdale. Here is the dyno sheet comparing my run shown in blue with their demo bike shown in red. It looks like I am down a couple HP and lb./ft. of torque vs. the full termi kit they had on the demo. Interesting that the curves are nearly identical just slightly different power levels. They didn't have a run from a stock bike, so no comparison with that dyno.

It runs pretty smooth, but I haven't got a real ride in yet, so I can't say for sure what it performs like. It sounds pretty damn good though. I might have to do the header and cat eliminator to get a couple more ponies for 3rd gear wheelies.



Out!

[AXE]

Here is a video/sound clip I shot too. Not great as one of my boys was cheering me along and my neighbor came home just as I was doing my fly by, then the camera battery puked. I'll try and get a couple more soon.

http://members.cox.net/rsbreeze/MOV01889.MPG

Out!

[lelenb]

Sweet Jesus, where is your helmet? Actually that kid is a great touch to the video.

[Motard-Menace]

I had my Dyno run done on the same unit at Euro and with the full Termi its slightly higher then yours but the curve looks about the same. Not even sure you can notice 2hp in most situations to be honest.

83.77 & 69.28

I bet the cat eliminator and full header would bump it up to that area.

[desmoworks]

Cool, not bad for a slip-on vs full system, but do you have the base runs of both bikes stock? Otherwise it is a bit hard to compare the two!

[speedfreak]

All I could think about is that little kid off of Indiana Jones.

[AXE]

Helmet????????? If your gonna sound like a Harley you can't wear a helmet! Actually, I always wear a helmet, except when posing for the camera. I actually took if for a quick lap around the block at the dealer after the tuning to see how it ran. I felt naked without gear..........strange it was!

The dyno room is sweet and one of the best I have seen. I forgot my camera so no pictures of the equipment or run.

When I scheduled the appointment, they said they had a base run of a stock bike. However, when I got there, that was not the case. I also seen a run from I think Boaterboy's Hyper clocking in around 90hp with all the goods.

I was planning on doing the cat eliminator sometime, but wanted to see where it was at without it. I think I will get the full system coat it black. I suppose that an extra 2+HP is worth another $500.

Out!

[parkcrf]

Randy,

Looking good! Glad to hear you were finally able to get everything done.

[donkeyman]

Sounds really good. Not like a Harley at all (at least on my laptop). Let us know how it goes when you've had a chance to ride it properly!

[AXE]

Here is another video/sound clip. Still doesn't do it justice, I think it sounds a little funky inside the garage and the open clutch cover is competing. Anyway, it gives you another perspective.

http://members.cox.net/rsbreeze/MOV01906.MPG

Out!