$10 off any Ducati Sequential LED Tail Light

[motodynamic_998]

Hello All Ducati.ms members,

Thank you for welcoming us into this wonderful forum. As a sponser we want to introduce our new generation LED tail light for the Ducati 748/916/996/998 and Ducati Monster. It features our Stop Alert function and Sequential Signals all controlled via a built-in microprocessor for accurate and reliable usability. Check out our website for more information.

Please use coupon code: DUCATIMS10 to receive $10 off the purchase of any Ducati LED Sequential Tail Light at www.motodynamic.com. $9.95 flat rate shipping anywhere in US. Hurry, offer expires 8/31/09.

Best Regards,
Harry

P.S. Please keep this within the Ducati.ms community

[rockk]

hey i purchased ur tail light led sequential signalunit for my 916 ducati, but the instructions are really bad, i want to install them now but i m totally confused, on the picture i cant see wich cable u connected with wich ones,

for ex.

i have 1 blue and 1 green cable from ur harness then 2 black, wich is the left one wich is the right one?

http://www.motodynamic.com/installation/D-998.pdf

on ur instructions u wrote, connect

BLACK WITH BLACK ANY

then

yellow- white /green

blue - white/black

first of all i dont even have those colors, and sins there are 2 signals left and right, each with 2x2 cables , makes 4, i have a blue a yellow and 2 blacks identical, how should i figure out wich goes with wich, wich is the + wich is the - ?

would ve been nice a step by step setup, and with some concludent pictures, i cant see nothing on ur snapshots in the instructions/.


apart from these, i really like your tail light, seams high quality and are really bright even in dailight, considering they are leds.

sry for my bad english, im writing in a hurry, going to try to install them now...

[motodynamic_998]

Rockk,

Thank you for contacting us. You have to remember not all the Ducati Superbikes worldwide have the same color configuration on the wires. With that being said, you basically have 4 wires, 2 ground wires and 2 positive wires for the turn signals. On this Ducati we worked on, there were 2 blacks (ground), one white/green stripe (+) and one white/black stripe (+). They are wired in pairs so you cannot mix them up. Your best shot would be a trial and error with a 50/50 chance to get it right. Don't worry about wiring incorrect because it will either work or not work and not cause anything to burn out. Just don't short the positive/negative wires to themselves on your harness.

Hopefully by the time you get this message you will have sorted it all. If not you can email us at sales@motodynamic.com for further assistance.

Regards,
Harry